Skip to main content
Application 01 / 07

Digital Signage PCBA Assembly for Always-On Displays

A signage player is expected to boot, decode and drive a screen for years with no operator nearby. We assemble X86 and Android player boards using SMT, DIP and mixed processes, then verify them with ICT, FCT and aging test before packing.

Pain Points in Signage Hardware

These are the failure modes our process is designed to screen out.

Continuous duty

Displays run for long hours; weak solder joints appear only after thermal cycling.

Fine-pitch packages

Player boards use BGA and QFN devices that cannot be inspected from the top alone.

Heat near the panel

Power and driver sections sit close to the display and need stable assembly quality.

Field replacement cost

Once installed, a board is expensive to reach — early screening matters more than speed.

Process Route

BOM and Gerber review

We check package data and board files before line setup. Email BOM and Gerber files to yun@dhc-pcba.com; we return a quotation within 24–48 hours and sign an NDA on request.

SMT and mixed assembly

SMT places BGA, QFN, 0201 and 01005 components; DIP handles connectors and larger parts on mixed-technology boards. AOI follows reflow.

X-Ray verification

BGA solder joints are checked by X-Ray; void rate is kept below 15%, including on 0.3mm BGA packages.

Test and coating

ICT and FCT verify the assembled board. Conformal coating can be added where the display is installed in a humid or dusty location.

X86 signage player mainboard assembly — image placeholder
Representative mainboard

X86 or Android player board

Signage products in our factory typically arrive as X86 compute boards or Android control boards. We do not publish board specifications that are not confirmed for your program — send your files and we will confirm the assembly route against your actual design.

See all four mainboard platforms →

Test Plan

Every lot is traced with batch-level COC through IQC, IPQC and OQC.

ICT

In-circuit test confirms placement and solder continuity on the assembled board.

FCT

Functional test exercises video output and the interfaces used by your signage enclosure.

Aging test

Extended powered operation screens for early-life failures before shipment.

Delivery & Documentation

Finished boards leave the 2,600㎡ Shenzhen facility with IQC → IPQC → OQC records and batch-level COC. Our ISO9001:2015 process supports a factory yield of 99.7% or higher. NDA protection is available before you send design files, and the main contact for this program is yun@dhc-pcba.com.

Quote a signage control board

24–48h response · NDA on request · BOM/Gerber by email.